Riding lawn mower won’t start no clicking. Riding mowers make mowing the grass a breeze, and they significantly reduce the time it would take to do it with a typical push mower.
However, these helpful machines are not immune to problems and hiccups, making the task tough, if not impossible.
If your riding mower won’t start and won’t even produce a click sound when you try to start it, the most common problem is with a device called the starter solenoid or the coil associated with it.
It is necessary to comprehend how the system works to understand better why you are having problems starting up your riding mower.
Riding lawn mower won’t start no clicking
There can be possible aspects that may lead to riding a lawnmower won’t start any clicking.
Please continue reading to find out why your riding mower isn’t making a click and won’t start, as well as how to fix it.
Wiring
To begin, the positive red battery line is attached to one of the two terminal posts on the starter solenoid.
These are big pots that are easy to spot. The other terminal post is connected with a black cable. You need to check the wiring for the following purposes:
- This wire is responsible for transferring power to the starter motor, which starts the mower’s engine.
- There’s also a little red wire that breaks off from the terminal post.
- This red wire connects the ignition switch to the starter solenoid’s coil, positioned at the bottom.
- Finally, when you turn the ignition key to the start position, the ignition switch is expected to deliver power to the white wire, which powers the solenoid coil.
- Following that, the coil will close an electronic point of contact, allowing electricity to be transferred from the red power cable to the black wire.
- This, in turn, will turn on the engine’s starter motor and start it up.
Dead or faulty Battery
A dead battery will not be ready to initiate the mower, and it will also explain why you don’t hear the unmistakable click sound while turning the engine over.
Due to a lack of electricity, the solenoid coil is unable to click. If you suspect this is the problem, use a multimeter to test the voltage across the battery’s connections.
Before you do so, be sure you’re taking the necessary safety steps.
A voltmeter is required to test a battery, but try this simple test if you don’t have one. Turn on the hood lights and dash lights if your mower has them. Your battery is most likely not the issue if they light up and are bright.
Charge the battery – If your battery is entirely dead, it will take many hours to recharge it and will necessitate the use of a battery charging hack.
Control module and fuse
The control module’s job is to receive a start/stop instruction from the ignition switch and only send a start command to the starter if all the correct sensors are engaged.
These modules can be visually examined for connectivity issues or water damage to the printed circuit. Every module will have an internal or external fuse. Please take a look at it.
Make sure there isn’t a blown a fuse. This is straightforward because you can typically determine if something is blown just by looking at it. If you discover that it is blown, go out and buy a new one.
Riding lawn mower won’t start after sitting
After checking the gas, oil, filter, and spark plug to make sure that your mower is in good working order, it’s highly recommended that you clean out the carburetor thoroughly.
You could try cleaning the carb by soaking it in a strong solution of vinegar or in a carb cleaner to see if that helps to get your mower running again.
Riding lawn mower won’t start after hitting something
It sounds like the blades are stuck. You may need to turn the mower over and remove the blades or see what is causing them not to move.
Basically, all you need to do is put it back together again or turn the mower over again and restart it.
Riding lawn mower won’t start without starting fluid
If your lawn mower won’t start without starter fluid, your first step is to diagnose the problem. The mower could have a dirty air filter, a bad spark plug, or a dirty carburetor, or it could just need fresh fuel.
The easiest thing to do is clean the air filter, drain the gas tank, and re-fill it with fresh fuel.
Conclusion
Riding lawn mower won’t start no clicking. Now that you know what could be causing your riding mower not to start or even make a clicking noise, you can focus on resolving the problem.
The majority of these issues may be recognized and resolved in a matter of minutes, but if you try everything and the mower still won’t start, you may need to contact a professional to have it inspected and repaired.
Related Guides
