Drilling holes in studs for electrical wire. Have you ever noticed that walls studs look exactly like Swiss cheese? Lol. Structural stability being the long-term factor, is an important aspect of strong buildings.
Are you planning to renovate your early 70s house and have decided to replace the aluminum wires with copper ones? OR do you want an additional or extra circuit for your new appliance?
Isn’t it annoying enough to see your electrician creating multiple holes in your beautiful-looking wall?
Moreover, it will not give a good impression on your guests, especially when you have recently decorated your house and walls. There are many other ways to drill holes in studs.
Let’s find out a better way of drilling wholes in Studs for electrical wire.
How to Drilling holes in studs for electrical wire?
- Choose the drill size that is right for the job once you know the size of the hole you need (based on how many threads you want to lay through the hole).
- Ensure that you can easily pull through the wires, drill holes at least 14 inches larger than the needed hole size.
- Begin by designating the center of the bolt for the location of the hole to be drilled. Whether the rule is bearing or non-bearing, you should always drill exactly in the middle of it to maintain it as secure as possible.
- Pull the wires through once you’ve drilled to the other end. If you cut the wire too short and need it later, leave about 1 foot of extra wire curled up in the wall.
Why is there a need for wholes in studs?
When you build with wood, you get a wonderful, strong framework, but wood is solid, and when you plaster over it, you need a good seal to prevent draughts or unwanted vermin from getting in between the walls.
Because cables cannot readily pass-through wood and plaster, you must either drill a hole in the center of the stand or remove a square notch on the side of the stand.
How do I know if I can drill into a wall?
The most difficult aspect of hanging large goods is that they may require a bolt for support. It is feasible to hang a heavy object from a stud, but you must first determine the thickness of the stud and the way the wires are joined to it.
This varies greatly depending on the year your home was built and the level of competence used in its construction.
Do not be surprised if inconsistencies are hidden behind the walls if other elements of your home appear to have been organized by a layperson.
Things to be aware of
Check your local construction code for any restrictions on the size of boreholes in both load-bearing and non-load-bearing walls. Before installing new wires, call an electrician if your walls are paneled with wood paneling.
Panels are tough to repair, and the stains are usually quite visible. Pulling cables through the panel walls may be preferable to using a surface cable.
What size hole to drill in studs for wiring?
Most electricians like working with two cables that are 1/2-inch in diameter. To install three circuit cables or more, you should use five / 8 -inch / 16 -millimeter holes instead for strength and durability.
Conclusion
You don’t need to hire an expert or an electrician if you want to this post focusing on how to drill holes in wall studs for wiring. We hope you will enjoy your next DIY project by applying the techniques mentioned above. Also, you can easily drill holes across the wall without letting them be invisible in front of your guests.
We hope that you’ve found our guide beneficial in solving your drilling problems on which you’ve wasted bulks of your salary.
Related Guides
