Bathtub drain stopper stuck in closed position

Bathtub drain stopper stuck in closed position. A bathtub drain stopper that isn’t working correctly is an annoyance. The problem is usually simple to resolve, albeit the steps differ depending on the level of bathtub stopper you have.

Some drains feature spring-loaded plugs activated by a toe or arm push, while others have a trip-lever positioned on the bathtub’s overflowing plate. Because of its intricate design, a trip-lever drain stopper is more challenging to repair than most.

Bathtub drain stopper stuck in closed positionwhy bathtub drain stopper stuck in closed position

To clear the drain, you must remove the stopper and allow it to move freely. Before you remove your drain stopper, make sure you know what it’s for. 

Fix through springs

The operation of a trip-lever drain that works a pop-up stopper is slightly different. Instead of a lift-bucket plunger, a spring at the end of the connecting rod closes a drain aperture at the bottom of the overflow tube.

This spring pulls down on a pivot arm when the trip lever is pushed, which levers the pop-up stopper up into an open position. Gravity allows the block to descend back down and shut the drain opening when the trip lever is moved to the closed position.

To get this task done, you need to follow these steps:

  • Remove the overflow cover plate’s fastening screws from the overflow tube. Remove the cover plate with care, then detach the connecting rod and spring via the overflow hole.
  • Remove any debris from the spring at the stopper linkage’s end. Hair and soap scum build-up can create difficulties with the stopper in many circumstances.
  • Attach the cover plate to the overflow tube and re-insert the stopper linkage through the overflow aperture. Turning on the water and checking that the stopper is in proper working order.

Toe technique

You may either receive the entire tiptoe assembly or only the top part and the rubber gasket when you detach the tiptoe. The portion at the bottom of the tub drain that you press to keep the water in or out.

This cartridge’s spring is broken, which is why it won’t open correctly. To remove this tiptoe cartridge, use a big screwdriver to unscrew it counterclockwise. Bring this tie-toe component to Home Depot, and they’ll match it up for you.

No need to contact a plumber; put the entire assembly back together, and you’re good to go. In certain circumstances, a screwdriver will not be able to remove this part. Thus you may need to use a pair of pliers to hold the outside of the cylinder and unscrew it this way.

The pop-up drain

Depending on the pop-up design, this may need lifting the lever on the overflow plate or turning the container to the right or left. Sometimes faceplates have labels that tell you which direction to spin the plate to get the stopper in the correct location.

  • To open the stopper, rotate the overflow faceplate or switch the lever.
  • To detach the stopper, pull upwards. You may have to shift it about a bit.
  • A few of these stoppers are equipped with a rocker arm that extends from the stopper. If you’re going to place it on the tub, make sure you have a cloth to lay it on.
  • Reinstall the stopper and plunger with fresh ones and double-check the seal.

How to remove a stuck bathtub drain stopper?

Unscrew the stopper with a screwdriver. Grab the stopper and pull it out of the drain. Place a drain key, also called a drain snake, in the pipe and turn it to loosen any buildup or debris.

Conclusion

Bathtub drain stopper stuck in closed position. Showers and baths are tiny pleasures in life, but if the Bathtub drain stopper is stuck in the closed position, you may follow the above-mentioned steps.

It may appear that it will remain stuck indefinitely at first, but this is nothing to be concerned about. Follow along as we go over the accessible methods for dealing with a jammed stopper.

Related Guides