how to reset genie garage door opener

how to reset genie garage door opener? This article will lead you to the resetting of the genie garage door opener. In this article, general information on programming and resetting is provided.

Genie garage doors are easy to use remote-controlled devices. Genie garage door openers are attached to the ceiling of the garage. The remote is a smaller device that consists of 1 or 2 buttons. These doors do not wobble the entire house when someone enters the garage or go out. These doors are now updated so now your remote needs to be sync or re-sync.

The resetting of your genie garage door opener is as the crow flies. To reset your genie garage door openers, you will have to reprogram the opener first and then reset the wireless keypad.

Let’s talk about

how to reset genie garage door opener by reprogrammingHow To Reset Genie Garage Door Opener By Reprogramming

Following are general steps on how to reset the genie garage door opener.

Pressing the square button

First of all, you have to press and hold the square button which is called the Program Set. Press this button for 3 seconds. When you will be holding it for three to 3 seconds the circular LED light will lit up. This rectangle-shaped LED light will deliver circular purple.

All the models of genie door openers have different buttons. Some models have LED light in a single line however some come in a form of a bunch.

Selecting the Learn code button

The learn code buttons are present on the older models. You can reset the opener by holding it.

Push the remote button

There are two buttons on your remote. Press the button once. You can push the button of your choice. But remember the button you pushed for the first time. this button will let you open or close the garage door.

Pressing the buttons

Now, you have to push the button to open the garage door. When you have pushed the button, the LED light will turn blue. So, your opener is now reset and synced. at this moment, you have your new remote settings.

The second step of resetting is the setting of your wireless keypad. Now, come to the Resetting the wireless keypad. This resetting involves the following three steps:

Pressing Down keys

There are two buttons on top of the keypad. You have to press the Down button for 5 seconds. If the LED of your wireless keypad blinks twice and then turns dark, it means that your reset has been successful.

Press the 3, 5, and 7 in sequence

Let your device to the Program Set button and press it for about 3 seconds. Now, push buttons 3, 5 and then 7 in a sequence.

Pushing up/down buttons

On the bottom of your keypad, there are up/down buttons are present. At this time, when you have pressed the 3, 5, and 7 buttons, now deliberately push the up/down buttons. The pushing of these buttons will allow the door to move. To check if your keypad is properly synced, again press the 3, 5, and 7 buttons.

Reset a Genie Garage Door Opener Updated

Here you can find out Best non stick pan without teflon.

Check out Best solar lights consumer reports

Leave a Comment

1